How to 3D Print a Photo: Lithophane Settings That Work
Published 2026-11-18
The short version
Turn the photo into a lithophane, print it upright in white PLA at 100% infill with 0.12 mm layers, and light it from behind. Everything else is tuning.
Step 1: pick the right photo
A lithophane is a thickness map, so it needs light and shade to work with. Photos shot in flat overcast light come out flat. Photos with a clear light source and a mid-tone subject come out with depth.
What works: a portrait against a bright window, a pet in daylight, a building with strong shadows. What does not: a night photo, a screenshot, a very dark image, anything where the subject is 10% of the frame.
Crop in until the subject fills at least a third of the frame. You cannot crop after the mesh is built.
Step 2: convert it
Open photo to STL, load the picture, keep the mode on Lithophane, and set:
- Width: 100 mm for a face, 150 mm for a group or a framed print.
- Depth: 3 mm. This is the difference between the thinnest and thickest point, and it is the single most important number after the photo itself.
- Detail: 140 px to start, 200 px if you see faceting on skin.
Build, then check the triangle count in the status line. Anything under about 60,000 is comfortable for a hobby printer.
Step 3: orient it in the slicer
Stand the lithophane upright — its largest face vertical, touching the bed along one edge. Laying it flat destroys the gradient: the layer lines then run parallel to the image and the print looks striped.
Use a 3–5 mm brim. Skip the raft. If the model is taller than 120 mm, add a 2 mm frame in the slicer or print a holder.
Step 4: print settings
| Setting | Value | Why |
|---|---|---|
| Layer height | 0.12 mm | Smooth gradients; 0.08 mm if well tuned |
| Infill | 100% | Light must pass through plastic, not air |
| Perimeters | 3 | Keeps the edges opaque |
| Speed | 40–60 mm/s | Slower layers bond better and diffuse light evenly |
| Filament | White or natural PLA | Coloured filament tints the whole image |
| Supports | None | A lithophane has no overhangs |
Step 5: light it
A lithophane in daylight looks like a blank white sheet. That is correct behaviour, not a failure. Put it against a window, a lamp with a diffuser, or a purpose-built LED holder 10–30 mm behind the print. The further the light source, the softer the image.
Troubleshooting
Grey and washed out. Depth is too low or the photo has no contrast. Raise depth to 3.5 mm and raise contrast in an image editor before converting.
Blown-out highlights. The source is overexposed. Recover the highlights first.
Visible stair-stepping on skin. Raise detail, lower layer height, and check that your belts are tight enough for 0.08 mm.
Print snapped off the bed. Tall thin parts need a brim and a slower first layer; 20 mm/s on the first 10 layers is a good rule.
It looks like a negative. Tick invert in the converter. Some photos, and all x-rays, are inverted relative to what the eye expects.
How long does it take
A 100 mm portrait at 3 mm depth weighs 25–40 g and takes four to six hours on a stock 0.4 mm nozzle. A 150 mm framed print takes ten to fourteen hours. That is the real cost of the gift — about a dollar of filament and an evening of printing.